1958-1964 Chevy Impala 13

1958-1964 Chevy Impala 13" or Larger Wheels Chrome Front Disc Brake Kit With Chrome 8" Dual Booster Master Cylinder

Prev
1958-1964 Chevy Impala Front Disc Brake Kit WITH 8

1958-1964 Chevy Impala Front Disc Brake Kit WITH 8" Dual Booster Master Cylinder

$1,995.00
Next
1984-1993 Ford Mustang Electric High Power Master Booster WITH Custom Bracket

1984-1993 Ford Mustang Electric High Power Master Booster WITH Custom Bracket

$1,995.00

1958-1964 Chevy Impala 13" or Larger Wheels Chrome Front Disc Brake Kit With Chrome 8" Dual Booster Master Cylinder

In stock
SKU:
5864-645
$1,995.00
SKU : 5864-645

NEW

Shipping's An Estimate


ZERO OFFSET - 10 3/4" Vented Rotors. Front Disc Brake Kit Includes: Everything you see in the picture including Hardware

 

FRONT DISC BAKE KIT INSTALLTIONS INSTRUCTIONS

WARNING: Installation of any component or kit should be performed by persons experienced in the installation and proper operation of brake systems. It is also the responsibility of the person installing any brake component or kit to determine the suitability of the component or kit for that particular application.

NOTE: After installation and before operating the vehicle a complete test function of the brakes under controlled conditions should be made. Make several stops in a safe area from low speed and gradually work up to normal speeds. DO NOT DRIVE WITH UNTESTED BRAKES! Always utilize safety restrains when operating the vehicle.

 

STEP 1: Be sure to check that your kit has all the necessary parts needed to complete this project.

STEP 2:  Start by disassembling front spindles, by removing backing plate, brake drums and shoes. Make sure you remove and clean all grease, and dirt from spindle shaft.

STEP 3: Install caliper bracket to spindle using supplied bolts, brackets should be pre assembled for you. (NOTE: Brackets are reversible, could be mounted in front or rear of the spindle to clear steering arm or sway bar. 

STEP 4: Make sure that you pack inner wheel bearing with appropriate grease, to do this place a large dollop of grease on your palm of your hand, with your other hand push bearing into the grease until you see grease coming out of the bearing. Now insert inner wheel bearing onto rotor.

STEP 5: Next, place rotor face down and install the grease seal, mount rotor onto spindle and install packed outer wheel bearing followed by spindle washer and cotter pin.

STEP 6: Finally, install caliper on to the caliper bracket, using supplied bolt. Torque caliper bolts to bolt specs. Make sure the bleeder screws are on top position! Connect your brake hose to your original brake line, secure the brake hose, and bleed brake system.

 

BUILT TO ORDER        2-3 Weeks For Processing Before Order Is Shipped        

DISCLAIMER: 

Improper installation, abuse, racing and/or modification WILL VOID WARRANTY.

 

 YearMakeModel
1959ChevroletImpala
1960ChevroletImpala
1961ChevroletImpala
1962ChevroletImpala
1963ChevroletImpala
1964ChevroletImpala
1958ChevroletImpala
Loading...
Scroll To Top